Operation guide, Maintenance guide lines – POSIFLEX Business Machines AURA 6800 User Manual
Page 10
Page 10
LAN POS Printer Manager
This utility can be used to manage multiple Aura-6800L’s connected in same
network under Windows as long as there is no conflicting IP in the network.
This utility can assign to each LAN printer a different device name for easy
recognition. In case of confusion, please check the MAC addresses listed in
this utility against the MAC address label you can find under each printer.
Any PC connected in same network can use TCP/IP to use Aura-6800L in the
way like a directly connected local printer. So, for direct I/O control by tools
like “HyperTerminal” all commands applicable to the serial or parallel
interface model can work on Aura-6800L in the same way, as Aura-6800
except the port must be TCP/IP with the IP address of the printer. Similarly,
for Windows printer driver setup, please “Add Printer” and select for “Local
printer” and select port “TCP/IP” with the printer IP address then uses the
same Windows printer driver of Aura-6800L.
Posiflex Wi-Fi POS Printer Manager for Aura-6800W
Please set the host system to the AD-HOC mode and the IP in the same
network segment with Aura-6800 which in the 192.168.192.XXX. The
Posiflex Wi-Fi POS Printer Manager (PP68WMgr.exe) must use with
Microsoft Comm control 6.0(MSCOMM32.ocx), therefore, please ensure that
MSCOMM32.ocx installed before start the utility. Please set the Aura-6800
into normal mode that can be search by this utility. After start the software, it
will automatically search printer by Broadcast or search by IP modes and show
as a list. After Aura-6800 showed in the list, the setting can modify. For
modify the printer setting through UART and UDP modes, please connect the
cable to serial port. Please notice that Aura-6800 will reboot automatically
right after change or update setting.
OPERATION GUIDE
MAINTENANCE GUIDE LINES
* Please turn off and disconnect power before opening the cover.
* The areas around the print head and motor become very hot during and just
after printing, DO NOT touch them.