POSIFLEX Business Machines AURA 6800 - Manual (Page 16)

Page 16
printer density and others. Following explanation is going to descript these two
switches setting.
DIP Switch
On bottom cover of the Aura-6800 series thermal
printer, there is screwed a metal plate for setup
window. In this window, there is an 8-position DIP
switch for printer setup. Please use proper tool to
change the switch setting when necessary. The
switch position counting starts from the nearest
edge of printer. The functions of each position may
evolve with the revisions of the firmware. The information below applies to
the latest version to the date of print of this manual.
The 8-position SW1 DIP switch works as following:
Switch
position
ON OFF
1
2
Baud rate definition (ref. separate table below)
3 Paper Width 58mm Paper Width 80mm
4
Line format (for 80 mm
paper) at 576 Dot/Line Line format (for 80 mm paper) at 512
Dot/Line
5 Busy on “buffer full” Busy on “buffer full” and/or “off line”
6 Cut without paper feed Cut with auto paper feed
7 Auto Cutter Disable Auto Cutter enable
8 Firmware Update Enable Firmware Update Disable
Effect of positions 1 & 2 on baud rate is defined as in table below:
SW1 Pos. 1
OFF OFF ON ON
SW1 Pos. 2 OFF ON OFF ON
Baud rate setup 19200 bps 115200 bps 9600 bps 38400 bps
Switch position 3 defines the paper width. When it place in “ON”, the paper
width will be 58mm. In other words, if it needs the paper width at 80mm then
please set to “OFF”. The application of 58 mm width paper roll in this printer
can be achieved through an optional spacing plate. For the installation, Please
refer to the earlier chapter of “SPECIAL ADJUSTMENTS”.
Switch position 4 is usually set to OFF for ESC/POS command application
that prints at 512 dots / line. Only technical users shall set this switch to ON
and make the printer work in the 576 dots / line format.