Pioneer AVIC F500BT - Manual (Page 107)

The map color does not switch
automatically between daytime
and nighttime.
[ Night mode] is set to [Day]. Check [ Night mode] setting and make sure
[ Automatic] is selected. (Page 81)
The screen is too bright. An improper value has been set on
“Brightness”. Check the settings.
The display is very dim. [ Night] is selected in “Night
mode ”.
Check the setting of [ Night mode] and select
[ Automatic] or [Day]. (Page 81)
An improper value has been set on
“Brightness”. Check the settings.
No sounds of AV source are pro-
duced.
The volume level will not rise. The volume level is low. Adjust the volume level.
A speaker lead is disconnected. Check the connection.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible. You cannot adjust these with
MULTI-CONTROL. Turn the volume up or down according to
[
Sound settings] on the “Navi Settings”
menu. (Page 86)
The person on the other end of
the phone call cannot hear the
conversation due to an echo. The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo. Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
There ’s no picture while this pro-
duct is attached on the cradle.
The parking brake cord is not con-
nected. Connect the parking brake cord, and apply
the parking brake.
The parking brake is not applied. Connect the parking brake cord, and apply
the parking brake.
The backlight of the LCD panel is
turned off. Turn on the backlight. (Page 95)
Nothing is displayed and the
touch panel keys cannot be
used. The setting for the rear view camera
is incorrect. Select the appropriate setting for the rear
view camera.
The shift lever was placed in [R]
when the rear view camera was not
connected. Press MAP button, and then press MENU
button to return to the
“Top Menu” and then
select the correct polarity setting for [ Back
Camera]. (Page 92)
There is no response when the
touch panel key are touched or
a different key responds. The touch panel keys deviate from
the actual positions that respond to
your touch for some reason. Perform the touch panel calibration. (Page
93)
Problems in the AV screen
Symptom Cause Action (See)
The screen is covered with the
caution message and the video
cannot be shown. The parking brake lead is not con-
nected or applied. Connect the parking brake lead correctly, and
apply the parking brake.
The parking brake interlock is acti-
vated. Park your vehicle in a safe place and apply
the parking brake.
No video output from connected
equipments.
No video output from connected
iPod. [ AV Input] setting is incorrect. Establish the setting correctly. (Page 78)
The connection of the USB interface
cable for iPod is incorrect. Connect both USB plug and mini-jack cable
side. (If only one connection has made, an
iPod will not work properly.) (Page 14)
Appendix
En
107
Appendix
Appendix