Pioneer DEH-P7000BT - Manual (Page 47)

3 Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 51.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select AUX1/
AUX2.
3 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put) can be used for full-range speaker ( FULL)
or subwoofer ( SUB W) connection. If you
switch the rear output setting to SUB W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
FULL).
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select REAR SP.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween FULL (full-range speaker) and SUB W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select
FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select
SUB W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
44).
! If you change this setting, subwoofer output
in the audio menu return to the factory
settings.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT ON are displayed and no audio ad-
justment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select TEL.
3 Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing
MULTI-CONTROL will switch be-
tween ATT (attenuation) and MUTE (muting)
and that status will be displayed.
Initial Settings
En
47
Section
04
Initial
Settings