Pioneer DVR-433H-K - Manual (Page 94)

The Initial Setup menu 13
94
En
Component Video Out Interlace • Select if your monitor/TV is not compatible with progressive-scan
video.
Progressive Select if your monitor/TV is progressive-scan compatible. Check the
operating instructions that came with your monitor/TV if you’re not
sure.
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB .
AV1 Out Video • Sets the AV1(RGB)-TV SCART output to standard composite video
(compatible with all TVs).
S-Video Sets the AV1(RGB)-TV SCART output to S-video. Recommended if you
are using a long SCART cable.
RGB Sets the AV1(RGB)-TV SCART output to RGB. Good quality but check
your TV for compatibility.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect
using the supplied video cable, or reset the recorder (see Resetting the recorder on page 111).
The Component Video Out setting (see above) has no effect when AV1 Out is set to
RGB .
AV2/L1 In Video • Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
standard composite video.
S-Video Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
S-video.
RGB Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
RGB.
Decoder Use this setting if you connected a decoder to the AV2/AUTO START
REC (INPUT 1/DECODER) SCART connector. For scrambled channels,
make sure that the channel Decoder setting is set to On . (See Manual
CH Setting on page 93.)
NTSC on PAL TV On • NTSC discs will play correctly on PAL-only TVs.
Off Use if your TV is already NTSC-compatible.
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with
your TV. See also About NTSC on PAL TV on page 99 for related information.
Audio In Settings
Nicam Select NICAM • Record the NICAM audio in a NICAM broadcast.
Regular Audio Record the non-NICAM audio in a NICAM broadcast. (You can still
switch the audio to record using the
AUDIO ( SHIFT + 1 ) button before
recording.)
Tuner Level Normal • Standard setting.
Compression Use if the audio level from the built-in tuner is excessive, causing dis-
tortion.
External Audio Stereo • Select if the audio from the currently selected external input is stan-
dard stereo.
Bilingual Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or
bilingual. This has priority over the setting you make here.
Setting Options Explanation
DVR-433H_UK.book 94 ページ ２００５年３月１日 火曜日 午後５時６分