Powermatic WP2510 - Manual (Page 25)

25
Step 5: Press ...............................................[select program key 1]
Step 6: Press
............................................[enter value]
Step 7: Press
..................................................................[complete]
Step 8: Press to exit.
Execute:
Step 1: Enter single mode, LED lamp is off.
Step 2: Press a key 0 to 9.
LED lamp is blinking, ready for start.
Example: Program 0 = 10.00mm; Program 1 = 20.00mm.
Step 1: In Single Mode, LED lamp is off.
Step 2: Press
...................................................[Program 0]
Now you will see the preset value: 10.00mm (Program 0]
LED lamp is blinking, complete.
Press to begin positioning.