Pride Mobility 6000Z 4S - Manual (Page 27)

Quantum 6000Z Series www.pridemobility.com 27
V . C O M F O R T A D J U S T M E N T S
Figure 20. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
QUICK
RELEASE
FASTENERS
Figure 21. Quick Release Fastener Operation
LEVER (OPEN)
BOLT
NUT
CAM
UNCLAMPED
CLAMPED
LEVER (FULLY
CLOSED)
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew in both armrests.
11. Route the controller harness to the back of the
power base and plug in the controller. See figures
12 and 13.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller harness to the armrest with
wire ties. See figures 12 and 13.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, refer to the information provided
in supplemental manuals provided with your seating
system.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different
heights in 0.5-in. (1.27-cm) increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 20.
2. Raise or lower the foot platform bracket to the
desired height.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 20.
2. Move the foot platform bracket in or out to the
desired depth.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See
figure 20. Each quick release fastener consists of a bolt, a lever, and a nut. See figure 21. The lever has a cam on
the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped.
When the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release
fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.