Pride Mobility 6000Z 4S - Manual (Page 28)

28 www.pridemobility.com Quantum 6000Z Series
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a
socket or wrench.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the screw. See
figure 22.
2. Turn the screw to raise or lower the front of the
foot platform.
Positioning Belt
Your power chair may be equipped with a positioning
belt that can be adjusted for operator comfort. See fig-
ure 23. The positioning belt is designed to support the
operator so that he/she does not slide down or forward
in the seat. The positioning belt is not designed for use
as a restraining device.
WARNING! The positioning belt should
be secured at all times. Never allow
the positioning belt to hang or drag on
the floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat
hinge to the seat base on both the left and right seat
hinges.
2. Insert the screw through the supplied washer,
through the positioning belt and into the seat base
for each side of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the
belt into the plastic housing on the opposite side
until you hear a click. See figure 23.
2. Pull the excess strap attached to the metal tab until
it is secure, but not so tight as to cause discomfort.
V . C O M F O R T A D J U S T M E N T S
Figure 22. Underside of Foot Platform
SCREW
Figure 23. Positioning Belt Adjustment
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of the
power chair. If you discover a problem, contact your Quantum Rehab Provider for maintenance
and repair.