Paradyne T1 Access Mux 916x - Manual (Page 2)

2
Network
Configuration Option Settings Default in [Bold]
Network 1, 2
Interface Status 1 Enable, [Disable]
Line Framing Format D4, [ESF]
Line Coding Format AMI, [B8ZS]
Line Build Out (LBO) [0.0], –7.5, –15, –22.5
Bit Stuffing [62411], Part68, Disable
Network Initiated LLB [Enable], Disable
Network Initiated PLB [Enable], Disable
Transmit Timing 3 [System], Network
ANSI Performance Report
Messages Enable, [Disable]
Management Link [Disable], FDL, DDL
IP Address 2 [000.000.000.000] – 223.255.255.255, Clear
Subnet Mask [000.000.000.000] – 255.255.255.255, Clear
Routing Information Protocol None, [Proprietary]
Network Time Slot 01–24 [lowest available time slot]
Circuit Identifier Text field
Loss of Signal (LOS) Alarm [Enable], Disable
Out of Frame (OOF) Alarm [Enable], Disable
Alarm Indication Signal (AIS) [Enable], Disable
Yellow Alarm [Enable], Disable
Excessive Error Rate (EER)
Alarm [Enable], Disable
Excessive Error Rate Threshold [10E-4], 10E-5, 10E-6, 10E-7, 10E-8, 10E-9
1 Read-only when Network is set to 1.
2 This first byte cannot be set to 0 nor 127. However, the null address of 0.0.0.0 is
valid after performing a Clear.
3 Only shown when 9261 T1 NAM is being used.