Plasmon MOD 910 - Manual (Page 13)

SCSI Connections
The external drive is equipped with two Micro D 50 way connectors on
the rear panel. These are for the SCSI in and SCSI out (if there are
additional devices connected).
A SCSI interface cable needs to be terminated at each end of the line,
one terminator being on the last device in the chain and the other
terminator is usually on the host computer or adapter card, a Micro D
SCSI Terminator is supplied (external drive only).
Refer to the documentation supplied with your SCSI card or computer
system should you need to check the computer termination. In normal
circumstances this will usually be enabled.
The two ways of connecting SCSI devices are shown below :
Fig 1. External Drive Connection
Fig 2. Internal Drive Connection
Fig 1 External Drive Connection
1.Switch block SCSI ID setting
2.SCSI connector for additional devices or terminator if last in chain.
3.SCSI cable
If there are also internal devices on the same SCSI card, then the SCSI
adapter card must have its on-board termination disabled.
4
97705183 A
User Manual