Plasmon MOD 910 - Manual (Page 18)

Notes:
If you need to use the emergency eject pinhole, make sure that the unit
is powered off and that the disk has stopped its rotation (20-30 seconds
after power off).
If the SCSI ID is changed with the unit powered ON, then power must
be removed and reapplied for the new ID to take effect.
Before moving the drive, always ensure that the optical disk cartridge is
removed.
The drive has various functions that may be altered from their defaults if
required. These are outlined in the MOD910I section. Opening the
enclosure and changing these settings must only be carried out by a
qualified service engineer.
Internal Drive
! The internal drive can be used in both the vertical and horizontal
plane.
! The external drive must only be used in the horizontal plane.
• Attaching screws are supplied with the unit. The screws are M3 x
8 mm, and the fixing plate should be within the range of 1.5 to
2.5 mm, which includes the washer.
• Included with internal drives is a 50-way flat IDC cable with 2
connectors for connection to the SCSI adapter.
Note for correct orientation of the flat cable when installing!
Pin 1 is usually identified by a red stripe on the edge of the
cable, and connectors have a small arrow by pin 1.
! Connect the internal power connector in your computer to the
drive making sure that the orientation is correct.
9
97705183 A
User Manual