Promise Technology 150TX2 - Manual (Page 51)

Chapter 4: Installing Software Drivers
47
Existing Windows NT4.0 Installation
The following section details the installation of FastTrak TX2plus drivers on a
system that has Windows NT4.0 already installed and running.
NOTE: Do not attach the boot drive or any other hard drive to the FastTrak
TX2plus controller card before completing this step.
1. From the Start menu, choose Settings.
2. From the Settings menu, choose Control Panel.
3. Double-click the SCSI Adapters icon. The SCSI Adapters dialog box
appears.
4. Choose Drivers then click Add.
5. In the Install Drivers dialog box, click Have Disk…
6. When Install From Disk appears, insert the FastTrak TX2plus driver diskette
in drive A:.
7. Type A:\NT4 in the text box window then click OK.
8. When the Install Driver dialog box appears, select WinNT Promise FastTrak
TX4000/S150 TX Series Controller then click OK.
9. When the Select SCSI Adapter Option dialog box appears, click Install.
10. After a successful installation, the SCSI Adapter Setup box will show that
the “WinNT Promise FastTrak TX4000/S150 TX Series Controller” has been
installed.
11. Power off your system.
12. If you plan to move the boot drive to the FastTrak card, do it now. Otherwise
reboot.
Removing Driver from Windows NT4.0
1. From Start, choose Setup then choose Control Panel.
2. In Control Panel, choose SCSI Adapter then choose Drivers.
3. Click the Remove button.
4. After successful removal, the SCSI Adapter Setup box will show that the
“WinNT Promise FastTrak TX4000/S150 TX Series Controller” has been
removed.