Planet Technology ADSL VPN/Firewall Router ADW-4200 - Manual (Page 63)

Chapter 3 Configuration
59
Connection Name: Give a name for this connection.
Local Network: Set the IP address, subnet or address range of the local network.
¤ Single Address: The IP address of the local host.
¤ Subnet: The subnet of the local network. For example, IP: 192.168.1.0 with
netmask 255.255.255.0 specifies one class C subnet starting from 192.168.1.1.
¤ IP Range: The IP address range of the local network. For example, IP:
192.168.1.1, end IP: 192.168.1.10
Remote Secure Gateway Address (or hostname): The IP address or hostname of
remote VPN device that is connected and establishes a VPN tunnel.
Remote Network: Set the IP address, subnet or address range of the remote network.
Proposal:
Select the IPSec security method. There are two methods to check the
authentication information, AH (authentication header) and ESP (Encapsulating Security
Payload). Check ESP for a higher security, data will be encrypted and authenticated.
Check AH, data will be authenticated but not encrypted.
Authentication: Authentication establishes the integrity of datagram and ensures it is
not tampered with in transmit. There are three options, Message Digest 5 (MD5),
Secure Hash Algorithm (SHA-1) or NONE. SHA-1 is more resistant to brute-force
attacks than MD5, but it is slower.
¤ MD5: A one way hashing algorithm that produces a 128 −bit hash.
¤ SHA-1: A one way hashing algorithm that produces a 160 −bit hash.
Encryption: Select the encryption method from the pull-down menu. There are four
options, DES, 3DES, AES and NONE. The NONE means it is a tunnel only, no
encryption. 3DES and AES are more powerful but increases latency.