Pioneer VSX-2016AV - Manual (Page 59)

Using other functions 11
59
En
• Press RECEIVER then press SLEEP repeatedly to set
the sleep time.
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again.
1
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
• Press RECEIVER then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press STATUS to check the system settings.
These appear on both the OSD and the front panel
display. 2
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel TONE button,
press and hold STANDBY/ON for about three
seconds.
The display shows RESET? .
3 Press the front panel ENTER button.
The display shows RESET OK? .
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
Off
30 min 60 min
90 min
ANALOG
ATT
MIDNIGHT/
LOUDNESS
VIDEO SEL
DIMMER
SLEEP
SR+
D ACCESS
DIALOG E S.RETRIEVER
iPod RECEIVER TUNER HDMI1
USB HDMI2 CD-R/TAPE
SHIFT
STEREO STATUS SIGNAL SEL
THX ADV.SURR
SBch
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
HDD
CH CH
DVD
2 If the Pure Direct mode is switched on, some settings above will show OFF , even though they are on.
Input source Listening mode
Signal select Surround Back Processing
Sound Retriever Video Select
MCACC Position
STATUS
DOLBY DIGITAL 3/2.1
PCM 96+DOLBY PLII MS
Signal Select : AUTO
SBch Processing: OFF
Retriever
: ON
Video Select : OFF
MCACC Position : M1
VSX-2016_HY.book.fm 59 ページ ２００６年２月２４日 金曜日 午後１２時４０分