Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T - Manual (Page 6)

6
2. Mount the UIM on the SMD2000-24T Printed Circuit Board (PCB). A
UIM may be installed in either Port 1 or Port 2, or both for redundancy purposes.
Using a Phillips screwdriver, remove the flathead screws from both sides of the
chosen port on the chassis faceplate. Remove the slot cover.
C AUTION :
If a slot cover is removed from Port 1 or Port 2, it must be replaced with a UIM.
Do not operate the SMD2000-24T with an open UIM port.
3. Carefully slide the faceplate of the UIM under the lip of the SMD2000-24T faceplate
at the selected port opening such that the UIM PCB is face down and the UIM label
shows through the port opening with the UIM model name along the right edge.
4. Align and secure the PCBs. Ensure that the connector key pins and the four
mounting holes on the UIM PCB are lined up with the board-to-board connector and
the four corresponding standoffs on the SMD2000-24T PCB. Gently press down
with even pressure on all four corners of the UIM until the board-to-board connector
is fully seated. Using a Phillips screwdriver, secure the UIM PCB to the
SMD2000-24T PCB at the standoffs with the four provided pan-head screws.
Standoffs
UIM Side View