Pelco TLR3040 - Manual (Page 16)

16 Pelco Manual C671M (1/01)
CONNECTING FOR EXTERNAL TIME CLOCK ADJUSTMENT
Figure 6. Connecting for External Time Clock Adjustment
If ALARM REC DURATION in the Recording Set Up menu is set to other than MAN 1, the
on-screen clock can be reset to the nearest hour by applying a signal to the RST (reset) IN
terminal. For example, if the current time is 11:29:59, it will be reset to 11:00:00, and if the
current time is 11:30:00, it will be reset to 12:00:00.
CONTROLS
FRONT PANEL
00253
GND ALM RST
IN
REC ALM MODE CLK
OUT
CALL GND ALM RST
IN
REC ALM MODE CLK
OUT
CALL
*1
1ST VCR 2 ND VCR
*1: WHEN CONNECTING THE MODE OUT TERMINAL OF THE FIRST VCR WITH THE RST IN TERMINAL OF THE
SECOND VCR, THE ON-SCREEN CLOCK OF THE SECOND VCR CAN BE ADJUSTED TO THAT OF THE FIRST VCR.
00254
POWER
PICTURE
SOFT SHARP
REC/PLAY MODE TRACKING
JOG/ADJUST
EJECT REC
SHUTTLE
CLEAR/ REW ENTER/ FW
MENU /
TIME DATE ADJUST
PLAY/
REC CHECK
COUNTER
RESET
PAUSE/ SUTTLE HOLD
STOP
SEARCH TIMER REC
POSITON/ VERTICAL ADJUST
3 4 5
6
7
16 17
15
14 13 12 11 10 9 8
1 2
FLUORESCENT
DISPLAY
1. POWER button
Press for on; press again for off. The POWER indicator lights when the VCR is turned on.
2. Cassette loading slot
Insert the cassette in this slot to load it.
3. SHUTTLE ring
Use to adjust the playback speed and to program the menus. Turn this ring to the right
to advance the tape or to forward search. Turn it to the left to rewind a tape or to reverse
search. You can also use it to clear the alarm list, power loss list, timer recording, and to
initialize the menu programming. It also lets you program or exit the menus after setup.
4. JOG dial
Use to advance or reverse the tape frame-by-frame and to program the menus.
Figure 7. Front Panel