Pelco TLR3040 - Manual (Page 28)

28 Pelco Manual C671M (1/01)
CALL OUT Sets the call signal output at the end of the tape. Turns on or off the
signal coming from the CALL terminal when the end of the tape is
reached during recording. If a problem occurs during recording, a call
signal is output from the CALL terminal on the rear panel regardless of
the CALL OUT setting.
• WRNG•TAPE END – The VCR outputs a call signal at the end of
the tape or when a malfunction occurs. What the VCR does when
the tape ends depends on the setting for TAPE END in the First
Time Set Up menu.
• WRNG•REMAIN – The VCR outputs a call signal when the tape
has about nine minutes left (in 8H mode) or when a malfunction
occurs.
• WRNG – The VCR outputs a call signal only when a malfunction
occurs.
REAR TERMINAL MENU
Figure 17. Rear Terminal Menu
<REAR TERMIN
CALL OUT WRN
CLOCK OUT
MODE OUT
REC IN
CALL OUT
setting
TAPE END
setting
STOP
REWIND
REPEAT
ALARM
•PROT
WRNG•TAPE END WRNG•REMAIN WRNG
When there
are alarm
recordings
during
recording
When there
are no alarm
recordings
during
recording
Outputs a call signal at the
end of the tape.
Outputs a call signal at the
end of the tape for 2
seconds.
(same as above)
(same as above)
Outputs a call signal at the
end of the tape.
Outputs a low active signal
three minutes before the
tape ends.
(same as above)
(same as above)
(same as above)
(same as above)
When a malfunction occurs
in the VCR during recording,
a call signal is output.
(same as above)
(same as above)
(same as above)
(same as above)
Table A. Call Out/Tape End