Piega Thermo Check for Windows 1.6 - Manual (Page 13)

Page 9
Battery Replacement
Your ThermoCheck requires two (2) AA batteries to operate. You can use either alkaline or re-
chargeable (for example, NiCd or NiMH) batteries, however please remember that you must NEVER
attempt to charge alkaline batteries.
To insert the batteries:
1. Remove the ThermoCheck battery cover by placing the
unit face down, removing the two screws, and then lifting
the cover free.
2. Insert the two batteries with the correct polarity (as marked
inside the compartment and also on the label) into the
battery compartment.
3. Before replacing the lid, ensure that the batteries are fully
inserted. If the batteries are not inserted correctly, the lid
will not fit properly, and could consequently damage the
seal or the batteries.
4. Carefully place the cover of the battery compartment back
on, and gently tighten the two screws.
5. Your ThermoCheck is now operational.
Remember, do not attempt to charge non-rechargeable batteries. If you are using non-rechargeable
batteries with your ThermoCheck, ensure that the Recharge option is disabled (see Chapter 5,
Customising the ThermoCheck, for more information).
If you take less than two minutes for this procedure, the internal time clock will keep running.
Otherwise it may revert to midnight on 1 Jan 2000, and will need to be set next time a database is
sent to the unit. In the Settings panel (see Chapter 5), ensure the radio button labelled “Match
computer date and time” is selected.