Logging on and logging off – Piega Thermo Check for Windows 1.6 User Manual
Page 40
Page 36
Logging On and Logging Off
If there is a user list installed in the unit, you will need to log on to identify yourself before a reading
can be taken. If no users are currently logged on, you can do this by pressing the
key or
the
key, which will bring up the log-on screen. Only one user may be logged onto a single
ThermoCheck at one time, therefore logging a new user on to a ThermoCheck will log the previous
user off. It is optional to install a user list to the ThermoCheck.
You can log a user off by pressing the
key and then pressing the
key. If no PIN
code is entered, any user currently logged on is logged off.
The log-on screen prompts for a user PIN code by displaying “ENTER PIN:”. Type in valid user PIN
and press the
key. If the PIN is recognised, the display will show the user’s name on the
screen.
If you pressed the
key, the product selection screen will be displayed and you can select a
product and process/location as above. If you pressed the
key, you can now select a
product and process/location in the normal way by pressing the
key. The process of taking
readings is the same as when there is no user list installed in the unit, but the reading data stored will
always include the name of the user who was logged onto the ThermoCheck when the reading was
recorded.
You can continue taking readings without having to log on for each new product. When you have
finished, remember that you can log off by pressing the
key and then pressing the
key. For information regarding users, refer to Chapter 4, Setting Up a User List.