Pioneer AXM-P7650 - Manual (Page 22)

Using the position selector
One way to assure a more natural sound is to
accurately position the stereo image, putting
you right in the center of the sound field. The
position selector function lets you automati-
cally adjust the speaker output levels and in-
serts a delay time to match the number and
position of occupied seats. When used in con-
junction with the SFC, the feature will make
the sound image more natural and offer a pa-
noramic sound that envelops you.
1 Press p to select Posi.
Press p until Posi appears in the display.
2 Press m/n/q/r to select a listen-
ing position.
Press one of these, m/n/q/r, to select
a listening position as listed in the table.
Button Display Position
m F/L Front seat left
n F/R Front seat right
r FRONT Front seats
q ALL All seats
# To cancel the selected listening position,
press the same button again.
Note
When you make adjustments for listening posi-
tion, the speakers are automatically set for appro-
priate output levels. You can tailor them if you
want as discussed under the heading of Adjust-
ing the speaker output levels using a test tone or
Adjusting the speaker output levels.
Using balance adjustment
You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1 Press p to select Fad.
Press p until Fad appears in the display.
# If the balance setting has been previously ad-
justed, Bal will be displayed.
2 Press q or r to adjust front/rear
speaker balance.
Each press of q or r moves the front/rear
speaker balance towards the front or the rear.
Fad F 25  Fad R 25 is displayed as the front/
rear speaker balance moves from front to rear.
# Fad F/R 0 is the proper setting when only two
speakers are used.
3 Press m or n to adjust left/right
speaker balance.
When you press m or n, Bal L/R 0 is dis-
played. Each press of m or n moves the
left/right speaker balance towards the left or
the right.
Bal L25  Bal R 25 is displayed as the left/
right speaker balance moves from left to
right.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
1 Press p to select SLA.
Press p until SLA appears in the display.
Digital Signal Processor
En
22
Section
07