Pioneer AXM-P7650 - Manual (Page 31)

Display Equalizer curve
VOCAL Vocal
FLAT Flat
CUSTOM1 Custom 1
CUSTOM2 Custom 2
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
SUPER BASSPOWERFULNATURAL
VOCALFLATCUSTOM1CUSTOM2
Adjusting 3-band parametric
equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the front, rear and cen-
ter equalizer curves separately by selecting a
center frequency, an equalizer level and a Q
factor for each band.
! A separate CUSTOM1 curve can be cre-
ated for each source.
! A CUSTOM2 curve can be created com-
mon to all sources.
! The center speaker largely determines the
sound image and getting the balance right
isnt easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Press p and hold until SP Set appears
in the display, then press p to select PEQ.
After SP Set is displayed, press p until PEQ
appears in the display.
2 Press m or n to select the desired
item.
Each press of m or n selects the item in
the following order:
FRONT (speakers)Low (bands)Low (cen-
ter frequency)L (equalizer level)Q.WIDE
(Q factor)
3 Press q or r to select the speaker to
be adjusted.
Each press of q or r selects the speaker in
the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
# You cannot select speakers whose size is set
at OFF.
4 Press n and then press q or r to
select the equalizer band to be adjusted.
Each press of q or r selects equalizer
bands in the following order:
Low (low)Mid (mid)High (high)
5 Press n and then press q or r to
select the center frequency of selected
band.
Each press of q or r selects the frequency
in the following order:
40Hz50Hz63Hz80Hz100Hz125Hz
160Hz200Hz250Hz315Hz400Hz
500Hz630Hz800Hz1kHz1.25kHz
1.6kHz2kHz2.5kHz3.15kHz4kHz
5kHz6.3kHz8kHz10kHz12.5kHz
6 Press n and then press q or r to
adjust the equalizer level.
Each press of q or r increases or de-
creases the equalizer level. +6  6 is dis-
played as the level is increased or decreased.
Digital Signal Processor
En
31
English
Section
07