Front-panel displays, Additional information 15 – Pioneer DVR-650H-S User Manual

Page 126

Advertising
background image

Additional information

15

126

En

Front-panel displays

The table below shows a list of error messages that you may encounter when using the
recorder and an explanation of their meaning.

• There is no DV input or the input
signal is unrecordable.

No signal was detected at the

DV IN

jack. This may

appear if a blank section of DV tape is playing in
the connected camcorder.

• No DV camcorder connected.

The camcorder is not connected properly, or the
camcorder is switched off.

• You cannot connect more than one
DV camcorder at a time.

This recorder’s DV jack supports connection to
just one camcorder.

• Cannot operate the DV camcorder.

This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.

• Could not operate the DV camcorder.

This recorder was not able to operate the DV
camcorder.

• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.

The camcorder is in camera mode. Switch it to
playback mode.

• The printer is not ready or is not
connected. Please check the printer.

This message is displayed when communication
could not be established with the printer. See the

Troubleshooting

section if you do not know the

cause.

• Printing has been cancelled
because ...

This message is displayed when there is a printer
error during printing. After checking the printer for
the cause of the error, either reconnect the printer
and start the printing job again, or select “Yes” to
resume printing (select “No” to cancel the print
job). See also the operating instructions that came
with your printer for possible causes of print errors.

Message

Explanation/Action

• E01

The HDD may be damaged or broken. Please ask
your nearest Pioneer-authorized service center or
your dealer to carry out repairs.

• E02

As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 101) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.

Message

Explanation/Action

DVR650HS_TDR_EN.book 126 ページ 2007年4月9日 月曜日 午後12時10分

Advertising