Basic recording from the tv, Recording – Pioneer DVR-650H-S User Manual

Page 37

Advertising
background image

Recording

37

En

05

EP

(Extended Play) – Lower quality than

LP, but gives about six hours of
recording time on a DVD disc.

SLP

(Super Long Play) – Lower quality

than EP, but gives about eight hours of
recording time on a DVD disc.

SEP

(Super Extended Play) – Lowest

video quality but gives about ten hours of
recording time on a DVD disc.

MN1

to

MN32

/

LPCM

1

/

XP+

2

– Manual/

Linear PCM/XP+ (available only when
manual recording is on).

The setting is indicated in the front panel
display, and shown on-screen together with
the recording time for a blank recordable
disc. If a recordable disc is loaded, the
approximate remaining recording time for
that disc is also shown. (Note that if the On
Screen Display setting (see

On Screen

Display

on page 113) is

Off

then this

information is not displayed.)

Basic recording from the TV

Basic recording from the TV involves just
setting the channel to record, choosing
whether to record to the HDD or a DVD and
selecting the recording quality.

1

Select the HDD or

DVD for recording.

• If you’re recording to DVD, load a

recordable disc (if you load a new blank
DVD-RW or DVD+RW disc, the recorder
takes a short while to initialize the disc).

• If you want to record a VR mode DVD-R

or a Video mode DVD-RW, you must
initialize it before proceeding (see

Initializing recordable DVD discs

on

page 49).

2

Select a TV channel to record.

The front panel display shows the channel
number:

• While the recorder is stopped, you can

also use the number buttons on the
remote to select the channel (e.g., for
channel 24, press

2

,

4

then

ENTER

).

• If the recorder is stopped, you can also

use the

CH +/–

buttons on the front

panel to select the channel number.

3

Set the picture quality/recording

time.

• See

Setting the picture quality/recording

time

on page 36 for detailed instructions.

4

Select the audio channel to

record.

See

Changing audio channels

on page 36 for

more on this.

• When recording in VR mode (DVD) or

with HDD Recording Format set to Video
Mode Off (HDD), both mono and SAP
audio channels are recorded, allowing
you to switch the audio channel on
playback. The only exception to this is
when the picture quality is set to

LPCM

,

in which case you do need to select the
audio channel before recording.

5

Start recording.

If you want to set a recording end time, press
the

ì

REC

button repeatedly. The recording

time increases in 30 minute increments, up
to a maximum of six hours. The time the
recording will end is shown on-screen and in

Note

1 Audio is recorded in 16-bit Linear PCM format, video is recorded at

XP

quality. When recording a broadcast with

a SAP channel, select which audio channel to record (see

Dual Mono Recording

on page 107).

2 Applicable only to HDD recording. (If this setting is used when recording to DVD,

MN32

is used.) When copied

to DVD,

XP+

recordings are always copied in real time.

DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM HDD

HDD

DVD

CH

Channel number

ch

REC MODE

AUDIO

REC

ì

DVR650HS_TDR_EN.book 37 ページ 2007年4月9日 月曜日 午後12時10分

Advertising