Panasonic PT-DZ12000E - Manual (Page 47)

ENGLISH – 47
Basic Operation
Press ENTER. 3.
A “Change registered signals” screen will appear. •
RENAME
NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE SXGA60-A1
A1
RGB1
64.00kHz
60.00Hz
H(POS)
V(POS)
A B C D E F G H I J K L M N O
P Q R S T U V W X Y Z ; : , .
a b c d e f g h i j k l m n o
p q r s t u v w x y z / + - *
0 1 2 3 4 5 6 7 8 9 _ @ [ ]
< > BS OK CANCEL
Press ENTER. 4.
Note
To rename a registered signal, perform steps 4 and •
5 on page 46.
Procedure to switch to sub
„
memory
Press
◄► on normal screen
1.
(menu is not displayed).
The screen will show a list of the sub-memory •
registered for the currently entered signal.
Press
▲▼◄► to select the
2.
sub-memory signal to be
switched in the “SUB MEMORY
LIST”.
Press ENTER. 3.
Signal will be switched to the one that was •
selected in Step 2.
How to erase sub memory
„
The currently selected SUB MEMORY is deleted
by pressing DEFAULT at the “REGISTERED
SIGNAL LIST”.
On-screen indications
„
1 Input switching / signal switching
This shows the registered signal name on the
status screen for signal switching.
INPUT
NAME
MEMORY NO RGB1
RGB
A1(1-2)
2 Details of registered signal
REGISTERED SIGNAL STATUS
NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE SXGA60-A1
A5 (1-2)
RGB1
63.98kHz
60.02Hz
H(POS)
V(POS)
The designation can be set by the sub memory •
items.
MEMORY NO : A1 (1-2)
Sub memory number
The place in which address code (A1,
A2, ..., H7 and H8) signals are registered
Note
Restrictions
The maximum sub memory items that can be •
registered for the projector are 96 including the
basic signal.