Panasonic PT-DZ12000E - Manual (Page 75)

ENGLISH – 75
Special Featur
es
SDI SIGNAL LEVEL
z
Select the amplitude for the signals to be input.
This is only valid when YP
B
P
R
and RGB input of
HD-SDI. The setting will change as follows each
time the button is pressed.
64-940 4-1019
64-940: •
Normally set this.
4-1019: •
Set this when gray appears black.
On-Screen display setting
The user can specify the on-screen display.
Press
▲▼ to select
1.
“ON-SCREEN DISPLAY”.
AUX SDI IN
ON-SCREEN DISPLAY
BACK COLOR BLACK
Press ENTER. 2.
The “ON-SCREEN DISPLAY” screen will be •
displayed.
ON-SCREEN DISPLAY
OSD POSITION
OSD DESIGN
2
1
Press
▲▼ to select the desired
3.
item, and press
◄► to change
the setting.
OSD POSITION z
This sets the position of the on-screen display
(OSD).
1 (Top left of the
screen)
2 (Left centre of the
screen)
3 (Bottom left of the
screen)
9 (Bottom right of
the screen)
4 (Top centre of the
screen)
8 (Right centre of
the screen)
5 (Centre of the
screen)
7 (Top right of the
screen)
6 (Bottom centre of
the screen)
OSD DESIGN
z
This sets the colour of the on-screen display
(OSD).
2
3
4
1
6
5
1 • :
Displayed in yellow.
2: •
Displayed in blue.
3: •
Displayed in white.
4: •
Displayed in green.
5: •
Displayed in pink.
6: •
Displayed in brown.
OSD MEMORY z
This lets you save the cursor position in on-screen
menus.
OFF ON
INPUT GUIDE z
This sets whether to display the currently selected
input terminal name at the position set for “OSD
POSITION”.
OFF ON
WARNING MESSAGE
z
This sets the display of warning messages.
OFF ON
Back Colour
This sets the colour for the projection screen when no
signals are being input.
Press
▲▼ to select “BACK
1.
COLOR”.
ON-SCREEN DISPLAY
BACK COLOR
STARTUP LOGO
BLACK
LOGO3