Powerware 5115A USB User Manual
Page 11
4.
Plug the equipment to be protected into the UPS outlet sockets.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
5.
Start the UPS by pressing the
button as shown in Figure 2. The
indicator illuminates, indicating that power is available from the UPS
output receptacles.
The UPS conducts a self-test and enters Normal mode. If the alarm
beeps or a UPS alarm indicator stays on, see Table 8 on page 26.
The installation is complete. To learn how to operate the UPS, see
“Operation” on page 9.
NOTE The batteries charge to 90% capacity in approximately 3 hours.
However, it is recommended that the batteries charge for 6 to 24 hours after
installation or long-term storage.
5
Powerware
®
5115A USB User’s Guide
•
www.powerware.com.au