Powerware 5115A USB - Manual (Page 25)

19
Powerware
®
5115A USB User’s Guide • www.powerware.com.au
5. Replace the battery. See “Recycling the Used Battery” for proper disposal.
6. Connect the black battery cable to the new battery and then connect the red
battery cable.
7. Reinstall the battery.
8. Reinstall the metal battery cover and front panel.
Te s t i n g N e w B a t t e r i e s
NOTE: It is recommended that the batteries charge for 6 to 24 hours before testing.
Press and hold the button for three seconds to initiate a self-test. The 15-second
test automatically distributes the load to the batteries and tests the battery’s
performance. While the test is in progress, the indicators cycle through and the alarm
sounds. When complete, the UPS returns to Normal mode as indicated by the
indicator.
If there is a problem with the battery, the alarm beeps, the
indicator illuminates and
the indicator flashes. Check the battery connections and be sure the battery is fully
charged. Call your service representative if the problem persists.
R e c y c l i n g t h e U s e d B a t t e r y
Contact your local recycling or hazardous waste centre for information on proper
disposal of the used battery.
WARNING
• Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper
disposal of batteries is required. Refer to your local codes for disposal requirements.
• Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the
skin and eyes. It may be toxic.
CAUTION
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead-acid
batteries and must be disposed of properly. For more information, contact your local recycling or
hazardous waste centre.