Panasonic WJ-PB65E01 - Manual (Page 3)

3
Board Mounting Procedure
The following example is the procedure to mount a network
board into the OUT X-1 slot of WJ-SX650 Series.
Notes:
• This network board can be inserted into the OUT X-1
slot only.
• Before the procedure, power off WJ-SX650 Series.
• Remove the screws and fixing brackets surely when
dismounting.
• Fix the screws surely when mounting.
• Do not hit the boards against the chassis of WJ-SX650
Series.
1. Remove the front panel by loosening the screws.
2. Dismount the video output main board from the front
side.
3. Dismount the OUT X-1 board from the rear side.
4. Mount the network board into the OUT X-1 slot, and fix
the board with the supplied screws.
5. Mount the video output main board by hooking the
board stoppers on the board stopper angles at the front
side, by pushing down the board stoppers, and by fix-
ing the screws. Then, attach the front panel.
Note: When mounting, insert the main board surely into
slits.
Matrix Switcher WJ-SX
650
OPERATE
Video output main board
Fixing brackets (x4)
Screws (x8)
SIGN AL G ND
SIGN AL G ND
TERM .ON ON MODE TERM .OFF
MODE
DAT A 4 HDR 4/TM NL8 HDR 2/TM NL4
DAT A 3 HDR 3/TM NL7 HDR 1/TM NL3
DAT A 2 TMN L6 TMN L2
DAT A 1 TMN L5 TMNL 1/PS D ATA
Vide o Ou tput B oard 2
Vide o Ou tput B oard 1
OUT X-1 board
Fixing brackets (x2)
Screws (x2)
SIGNAL GND
SIGNA L GND
TERM .ON ON MODE TERM .OFF
MODE
DAT A 4 HDR 4/TM NL8 HDR 2/TM NL4
DAT A 3 HDR 3/TM NL7 HDR 1/TM NL3
DAT A 2 TMN L6 TMN L2
DAT A 1 TMN L5 TMNL 1/PS D ATA
Vide o Ou tput B oard 2
Vide o Ou tput B oard 1
Network board
Board stopper angle
Board stopper
• Mount the main board into the slot.
• Fix the board with the screws (x3).
• Attach the fixing brackets (x4) with the screws (x8).
Fixing brackets (x4)
Hook the board stoppers
on the board stopper angles, and
push down the board stoppers.
Screws (x8)