Panasonic WJ-PB65E01 - Manual (Page 5)

5
<TEST port> (Output front board)
■ Firmware Update Procedure
Note: The following is the procedure when using the
Windows XP operating system.
If you performed wrong operations, the monitor display
will return to Step 3. In this case, retry the operations.
1. Select "Start" - "All Programs" - "Panasonic" - "Firmware
version up software" - "Firmware version up software
x.xx". (x.xx is the version number.) Then, run the pro-
gram.
2. Firmware update software will start up, and the login
window will be displayed on the PC screen.
Enter the user name and password. The factory default
is as follows.
User Name: user
Password: 12345
3. Click "OK". "Firmware update software" window is dis-
played. Then, click "WJ-SX650 Series".
4. The following message will be displayed. Then, click
"OK".
5. "File Selection" window is displayed.
Click "Browse" to select the firmware file of WJ-SX650
Series for update.
The file is located in the following directory.
E:\PWriter\SX650_vXXXXX_yyyy.mot
(E is the CD-ROM drive, "X" is the software version, and
"y" is the checksum.)
Note: Make a note of version displayed in the "File
Selection" window. The version will be required for
checking in Step 7.
6. Connect the SERIAL port of WJ-SX650 Series and PC.
(Refer to the illustration of <SERIAL port> in p. 4.)
Then, perform the firmware update by following the
instructions given.
Notes:
• Firmware update procedure is as follows:
Current version check → Firmware update → New
version check
If the current version is the same as the version you
have noted down in Step 5, firmware update is not
required.
• When the "Version check completed" message or
"Firmware update confirmation" message appears dur-
ing firmware update, reconnect the cable (SERIAL port
↔ TEST port) and perform the MODE switch setting of
video output board for update.
SERIAL port: Connected for version check
TEST port: Connected for firmware update
9-pin D-sub
(Female)
9-pin D-sub
(Female)
Front side of WJ-SX650 Series
(Front panel detached)
PC
Cross cable
PULL
POWER
ON OFF
RESET No. MODE
RESET
TEST
MODE