Panasonic AG-HPX500E - Manual (Page 140)

140
Inspections Before Shooting
C
h
ap
te
r 9 M
ain
te
n
an
ce a
n
d I
n
sp
ec
tio
n
s
Inspection of the clock, time code, and
user bits
1
Set the user bits as required.
Please refer to [Setting the User Bits] (page
60) for the setting procedures.
2
Set the time code.
Please refer to [Setting the Time Code] (page
62) for the setting procedures.
3
Set the TCG switch to [R-RUN].
• Press the COUNTER button to display the
time code on the LCD monitor or in the
viewfinder.
4
Press the REC START/STOP button.
• Check that the counter display number
changes as recording progresses.
5
Press the REC START/STOP button
again.
• Check that recording stops and the counter
display number stops changing.
6
Set the TCG switch to [F-RUN].
• Check that the counter display number
changes regardless of recording status.
7
Hold down the DISP/MODE CHK button
to check the date and time on the LCD
monitor or in the viewfinder.
• Adjust the date and time setting if the DATE,
TIME and time zone is not correctly displayed.
For details, see [Setting Date and Time of
Internal Clock] (page 28).
<Note>
Note that date and time data set for DATE, TIME,
and time zone is recorded in clips, and affects
the playback sequence, etc. at the time of
thumbnail manipulations.