Panasonic AG-HPX500E - Manual (Page 85)

85
Power Supply
C
h
ap
te
r 5 P
re
p
ar
at
io
n
2
Insert the battery and slide it in the
direction of the arrow.
<Note>
●
Removing the battery pack
Completely push down and hold the release
lever on the battery holder. Then, slide the
battery pack in the opposite direction to the
arrow while holding the lever down.
3
Set the battery type.
• Select the battery type listed under BATTERY
SELECT. Select the menu option BATTERY
SELECT from the setting menu BATTERY
SETUP screen.
■ The following Anton/Bauer batteries can be
used:
• PROPAC14
• TRIMPAC14
• HYTRON50
• HYTRON140
• DIONIC90
• DIONIC160
Using an NP-1 type battery pack
When replacing the battery holder, consult your
distributor.
1
Remove the battery holder.
2
Mount the NP-1 type battery case on
the camera-recorder.
➀ Tighten the mounting screws.
➁ Tighten the power contact screws.
➂ Insert the upper part of the removed cover in
the direction of the arrow.
➃ Align the holes in the bottom part (metal part)
of the cover with the holes in the case, and
secure the cover with the screw.
<Note>
When mounting the battery holder, take care not
to pinch the connection cord.
Battery holder
Battery Case (for NP-1 type)
Release lever