Paradyne FrameSaver SLV 9664 - Manual (Page 107)

Operation and Maintenance
5-13 9664-A2-GB20-00 March 2000
Health and Status Messages
The following table provides Health and Status messages that apply to the
FrameSaver unit.
Table 5-7. Health and Status Messages (1 of 2)
Message What It Indicates
Auto-Configuration Active Auto-Configuration feature is active, which allows
automatic configuration and cross-connection of
DLCIs as they are reported by the network LMI.
Back-to-Back Mode Active The operating mode has been configured for
back-to-back operation (
Main Menu
→
Control
→
Change Operating Mode).
The FrameSaver unit can be connected to another
FrameSaver unit without a frame relay switch
between them.
This feature is useful for product demonstrations
or for a point-to-point configuration using a leased
line.
CTS down to Port-1 Device The user data port CTS control lead on the
FrameSaver unit is off.
DLCI nnnn Down,
frame relay link 1, 2
The DLCI for the specified frame relay link is down.
DTR Down from Port-1 Device The DTR control lead from the device connected to
the user data port is deasserted.
Link Down Administratively,
frame relay link 2
The specified frame relay link has been disabled
by the unit due to LMI Behavior conditions or LMI
Protocol on another link is in a failed state.
1 nnnn indicates a DLCI number of 16 through 1007.
2 frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-1. The frame relay link associated with the user data port.