Panasonic UF-490 - Manual (Page 58)

Receiving Documents
58
When your machine is set to this mode, your machine will switch to document reception or voice
communication automatically.
Setting the Fax / Tel Auto Switching Mode
Operation of Fax / Tel Auto Switching Mode
NOTE 1. The length of time the machine signals can be changed by Fax Parameter No.18 (OP CALL
TIMER). (See page 33)
2. To adjust the Ringer Volume, refer to page 21.
Fax / Tel Auto Switching Mode
1 Change Fax Parameter No. 15 (IN MODE) to 2: Fax / Tel SW.
(See page 33)
2
Make sure that the lamp goes off.
RCV MODE=FAX/TEL
If it is a Fax call,
1 Your machine will answer the call when a call is received,
then distinguish whether it is a voice or fax call.
2 Your machine begins to receive the documents.
If it is a Voice call,
1 Your machine will answer the call when a call is received,
then distinguish whether it is a voice or fax call.
2 Your machine begins to signal (ringing) through the
machine’s speaker for your attention. (See Note 1)
3 Lift the handset of the External Telephone and press
.
4 Begin the conversation .
STOP