Peachtree Woodworking Supply 600 - Manual (Page 2)

Step 3
The saw will be mounted to the Pro-Grip Saw Base with four
1/4” flat head screws (Not Included). The saw base plate will
have to be drilled for these mounting screws. Check both
sides of the saw base plate for clear flat areas to drill for the
mounting screws. From the bottom side of the saw base plate
mark the selected areas on the masking tape applied.
(See Figure 3)
Step 4
Using a 1/8”drill bit, drill a pilot hole at each of the four ar-
eas marked on the masking tape, then follow with a 1/4” drill
bit to drill the holes to the required size for the 1/4” flat head
mounting screws. The 1/8” pilot hole will keep the 1/4” bit
from moving as you drill and give a more accurate hole posi-
tion.
(See Figure 4)
Figure 3
Figure 4
Step 5
Remove masking tape from the saw base and debur the four
mounting holes drilled in Step 4.
(See Figure 5)
Figure 5
Figure 6
Step 2
Flip your saw upside down and place 2” wide masking tape
across both ends of the saw plate to make a marking surface
for the mounting hole locations.
(See Figure 2)
Figure 2
Step 6
Because the super slick UHMW Pro-Grip Saw Base will not
hold ink or pencil marks you will need to place two strips of
2” wide masking tape across the general areas where the saw
mounting holes will be located.
(See Figure 6)