Peachtree Woodworking Supply 600 User Manual
Page 3
Step 7
Place the saw on the tape runners and position the saw so
that the edge of the saw is in line with the edge of the Pro-
Grip Saw Base and centered to the length of the Pro-Grip
Saw Base. Use a strip of wood to keep the edges alined.
(See Figure 7)
Step 8
Using a 1/4” drill bit, mark the mounting hole locations on
the tape runners for all 4 corners of the saw by using a rub-
ber hammer to tap the end of a 1/4” drill bit marking the
tape for drilling locations. Insure that the edge of the saw is
even with the edge of the Pro-Grip Saw Base. These two edge
must be even to insure that the saw will cut parallel to the
Pro-Grip Straight Edge Clamp.
(See Figure 8)
Figure 7
Figure 8
Step 9
Define the drilling marks from Step 9 with a fine tip marker
or pencil.
(See Figure 9)
Figure 9
Figure 10
Step 10
Drill each of the 4 mounting holes with 1st a 1/8” drill bit the
to final size with a 1/4” drill bit. Remove the tape runners
from the Pro-Grip Saw Base.
(See Figure 10)