Peachtree Woodworking Supply 600 - Manual (Page 4)

Step 12
Install the saw blade on the saw, attach the saw to the Pro-
Grip Saw base using four 1/4” flat head screws with lock
washers, and wing nuts. (See Figure 12)
With the saw mounted to the Pro-Grip Saw Base check to
insure that the edge of the saw is even with the edge of the
Pro-Grip Saw Base and the wing nuts a are secure. These two
edge must be even to insure that the saw will cut parallel to
the Pro-Grip Straight Edge Clamp. (See Figure 12A)
Figure 12
Figure 12A
Step 13
With the saw attached to the Pro-Grip Saw Base from Step
12 plug the saw in, turn the saw on and slowly plunge the saw
blade through the Pro-Grip Saw Base.
Caution:
Be sure to position the saw so that you have clearance below
the saw blade before making the space below the saw before
making the plunge cut not to damage surface below.
Figure 13
Figure 11
CAUTION:
Please read, understand, and follow all manufacturers instructions, guidelines
and owners manuals that come with your power tools. Peachtree Woodwork-
ing Supply, Inc. and its subsidiaries assume no liability for accidents or injuries
caused by improper use of this product.
Step 11
Counter sink the four mounting holes from the bottom side
of the Pro-Grip Saw Base so that the heads of the mounting
screws are flush or slightly below the surface of the Pro-Grip
Saw Base.
(See Figure 11).
Note:
No mounting hardware is supplied with the Pro-Grip Saw
Base due to the varied types and thicknesses of saw base plates.
Please measure for the overall length of screw need for your
saw.
(See Figure 13)