Panasonic HYBRID IP-PBX KX-TDA50 - Manual (Page 42)

2.2 Installation of the Hybrid IP-PBX
42 Installation Manual
CAUTION
To protect the main board from static electricity, do not touch parts on the main board or on the optional
service cards. To discharge static electricity, touch ground or wear a grounding strap.
Notes
• When installing or removing the optional service cards, the power switch of the Hybrid IP-PBX must
be in the off position.
• For each card, the maximum number that can be installed in the Hybrid IP-PBX is listed in "1.3.1
Optional Equipment".
• Any card that exceeds the capacity of the Hybrid IP-PBX will be ignored.
• When the Hybrid IP-PBX starts up with an invalid configuration, some cards will be ignored.
Installing Optional Service Cards
1. Before installing the optional service cards, cut and remove the appropriate dummy cover plates from
the main unit.
CAUTION
For safety reasons, smooth the cut edges after removing the dummy cover plates.
SVM2 2
*1 Including one LCOT4 card that is installed by default.
*2 Only one of the HLC, DLC4, SLC4 or PLC4 card can be installed.
*3 A maximum of two DLC8, SLC8 and PLC8 cards can be installed.
Card Slot Number
Type Max 02 03 04 05 06 07 08 09 10 11
Dummy Cover Plate