Precor p20 - Manual (Page 99)

Chapter
4
Self-Powered Features
Important: This chapter of the manual describes Precor fitness
equipment that can operate without being connected to AC
power. This includes units equipped with P30 or P20 consoles.
However, P80 consoles must be connected to AC power through
their power supplies to operate. For this reason, this chapter does
not apply to units equipped with P80 consoles.
On self-powered equipment, the system initializes and
displays the Welcome screen when a user starts exercising. A
minimum rate of motion must be maintained for the banner to
appear, as shown in the following table. When a person meets
the requirements, the power that is generated allows the
equipment to function properly.
Table 4. Minimum requirements for operation
Equipment Rate of Motion
AMT
56 strides per minute (SPM)
EFX 40 strides per minute (SPM)
Climber 30 steps per minute
Bike 20 revolutions per minute (RPM)
Informational displays appear when the battery is low or
when the rate of motion drops below the minimum
requirements. The display explains what to do to retain
power. If the messages are ignored, the equipment begins
shutdown procedures to maintain the charge of the battery.
Refer to Informational Displays Prior to Shutdown.
An optional power adapter can be purchased and provides
sustained power to the equipment. If you plan to change the
club settings, the power adapter is highly recommended. To
purchase the optional power adapter, check with your dealer.
Refer to Obtaining Service.