Panasonic SC-HT830V - Manual (Page 9)

9
RQT7921
[Note]
The included AC power supply cords are for use with this unit only. Do
not use them with other equipment.
STEP
5
Radio and system connection
A
AC IN
RF IN
RF OUT
LOOP
EXT
75
AM ANT
FM ANT
LOOP
ANT
GND
A
DIGITAL TRANSMITTER
DVD/VHS EXT DVD
L
R
COMPONENT VIDEO OUT
Y
P B / C B
P R /
C R
S-VIDEO OUT IN OUT
VIDEO
1 2 4
3
TO SB-WA830
System cable AM loop antenna FM indoor antenna 2 AC power supply cords
Adhesive tape
Fix the other end of
the antenna where
reception is best.
AM loop antenna
Stand the antenna up on its base.
Place the antenna where the
reception is best.
Keep loose antenna cord away from
other wires and cords.
System cable
FM indoor antenna
Catch up
To disconnect
Press the catch and
pull out.
Click!
Connect the AC power supply cords after all other connections are complete.
Loosen the terminal
with a Phillips-head
screwdriver.
Red
White
Main unit
Push and insert the
antenna cables in as
far as possible. Tighten the terminal
screw again.
Subwoofer
Catch up
AC power supply cord
To household AC outlet
(AC 120 V, 60 Hz)
To disconnect
Press the catch
and pull out.
To household AC outlet
(AC 120 V, 60 Hz)
AC power supply cord
Black
Set your surround sound free!
Panasonic SH-FX50 Digital Transmitter and Receiver
(optional)
When you insert the digital transmitter into the DIGITAL TRANSMITTER slot of the main unit and
connect the surround speakers to the receiver, you can enjoy wireless surround speaker sound
except when VHS audio type is on mono sound mode.
For details, please refer to the operating instructions for Panasonic SH-FX50 Digital Transmitter and
Receiver.
RF IN
RF OUT LOOP
EXT
75
AM ANT
FM ANT
LOOP
ANT
GND A
DIGITAL TRANSMITTER
S
TO SB-WA830
AC power supply cords
Connect both AC power supply cords to enjoy all the features of
this system.
Demo function
When the unit is first plugged in, a demonstration of its functions
may be shown on the display.
If the demo setting is off, you can show a demonstration by
selecting “DEMO ON” in the standby mode.
Press and hold [–DEMO] on the main unit ( l 14).
The display changes each time you press and hold the button.
DEMO OFF
()DEMO ON
While in the standby mode, select “DEMO OFF” to reduce power
consumption.
DIGITAL TRANSMITTER terminal
RQT7921-P_ENG.book 9 ページ ２００５年２月４日 金曜日 午後４時５８分