Nokia WAP and SMS gateway - Manual (Page 73)

Chapter 5. Setting up a SMS Gateway
<alt-dcs>alt-dcs</alt-dcs>
</dcs>
<pid>pid</pid>
<statusrequest>
<dlr-mask>dlr-mask</dlr-mask>
<dlr-url>dlr-url</dlr-url>
</statusrequest>
<from>
<user>username</user>
<username>username</username>
<pass>password</pass>
<password>password</password>
<account>account</account>
</from>
<to>smsc-id</to>
<from>smsc-id</from>
<to>service-name</to>
</submit>
</message>
There could be several da entries for sendsms-user to enable multi-recipient messages. da doesn’t
make sence in sms-service .
ud
Note: Davi: I still have to test binary and unicode <ud> content
udh is the same format as X-Kannel-UDH . Example: <udh>06050415820000</udh>.
On kannel->application, from is the smsc-id that message arrives and to is the service name.
On application->kannel, from contains the credentials ( user/username , pass/password and
account and to corresponds to the smsc-id to submit the message.
user and username are equivalent and only one of them should be used. (same for pass and
password .
When application POST in kannel, as in GET, only user , pass and da are required. Everything else is
optional. ( oa could be needed too is there’s no default-sender or forced-sender .
Warning
This is experimental code. XML format could and should change to fully met
IETF’s sms-xml standard (yet in draft) and additional tags needed by kannel
should be pondered.
66