Nikon MFX-1930 - Manual (Page 7)

2-1 Network Interface
2. Installation
2.1 Cable connection
∗ To connect the machine to an Ethernet network, a LAN cable (twist pair cable with
RJ-45 type modular connector) is required. (A LAN cable is not included with this
kit.)
1
Turn your machine off.
2
Plug one end of the 10Base-T/100Base-TX LAN cable (category 5) into
the LAN connector on the left side of the machine.
LINK lamp:
Illuminates when connected to the LAN.
LAN Connector
LAN cable:
10Base-T/100Base-TX cable
RJ-45 connector
ACTIVITY lamp:
Blinks when there is data trafic
on the LAN.
Connect to the Ethernet hub.
3
Plug the other end of the LAN cable into the 10Base-T/100Base-TX Eth-
ernet hub.
4
Turn your machine on.