NEC Express 5800/320Lb - Manual (Page 104)

4-20
IMPORTANT:
User password setup is not available before Supervisor password setup.
Do not set any password before installing the OS.
See the table below for setup options on the screen.
Option Parameter Description Your Setting
Supervisor
Password is [Clear]
Set Indicates Supervisor password setup status (view
only).
User Password
is [Clear]
Set Indicates User password setup status (view only).
Set Supervisor
Password Up to 7
alphanumeric
characters Press Enter to display the supervisor password
entry screen. With the supervisor password, all
SETUP menus are available for access. This
option is available only when you log into the
SETUP utility with the supervisor password.
Set User
Password Up to 7
alphanumeric
characters Press Enter to display the user password entry
screen. With a user password, accessing the
SETUP menus is restricted. This option is
available only if the Supervisor Password is
specified.
Password on
boot Enabled
[Disabled] Specify whether to request a password entry at
boot-up. Supervisor password setup is required
beforehand. When the supervisor password is
specified and this option is disabled, the BIOS
assumes that a system boot attempt is made by a
user.
Power Switch
Mask [Unmasked]
Masked Enable or disable the POWER switch on the
server. If "Masked" is selected, power-off with the
POWER switch becomes unavailable after OS
boot-up. (Forced shut down also becomes
unavailable. Forced shut down is a feature to shut
down by pressing the POWER switch for over
four seconds.)
Option ROM
Menu Mask [Unmasked]
Masked Enable or disable key entries during optional
ROM expansion.
[ ]: Factory-set