NEC 10930 95 - Manual (Page 12)

12
Installing And Using a Headset
To install an optional headset:
1. Plug the headset cord into the headset jack on the bot-
tom of the telephone.
2. The headset cord routes through the upper channel on
the right side of the telephone base.
To set up a headset Feature Key:
1. Dial #KP (#57 ).
2. Press the Feature Key you want to assign + HOLD .
3. Press INTERCOM .
– INTERCOM flashes (red).
4. Press a VOLUME key until you see HEADSET .
5. Press HOLD + SPEAKER twice to exit.
To turn the headset mode on and off:
1. Press your Headset Feature Key.
– The headset key is on while in the headset mode; off while in the normal handset mode.
– You can optionally dial
#HS to turn the headset mode on and off.
To use your headset:
1. While in the headset mode, you can do the following:
– Press a line key to place or answer an outside call.
– Press
INTERCOM to dial a co-worker on the Intercom.
– While on a call, press SPEAKER to hang up.
2. Keeping the above three things in mind, process calls normally using the convenience of a headset.
1093095_rev1-26.qxd 5/31/06 8:33 AM Page 12