NEC DTERM DTL-RPT-1 - Manual (Page 14)

2 - 4 Getting to Know Your Repeater
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1 D
term
Cordless DECT
S
ECTION
3 F
EATURES
T
Automatic registration to the base
T
Up to six repeaters per base station
T Up to three repeaters in a sequential or daisy-chain layout
T Two internal antennas to support two simultaneous calls
T
Repeater connection verification tone
T
Low power consumption
3.1 Specifications
The following specifications apply to the NEC D
term
Cordless DECT repeater.
AC Power Adapter: Input: 100 -240VAC 50 -60Hz (RJ-11)
Output: 5 V dc , 500 mA
Frequency Band: 1920MHz - 1930MHz
Transmit Power: 100mW
Receiver Sensitivity: <-91 dBm at 10 -3 BER
Standards: Designed in accordance with the Digital Enhanced Cordless
Telecommunications (DECT) standard
Compliant with TBR6, TBR22 (Generic Access Profile, GAP),
and ETS 300 700 - ETSI Wireless Relay Station Specification
S
ECTION
4 S
ETTING UP YOUR
R
EPEATER
Before installing the repeater, you need to activate the repeater mode on your base
and then register the repeater to the base and any handsets. Before you start the
registration process, be sure you have:
T
A working base
T
A working handset registered to that base
T
Any repeaters you want to register to this base (you must complete the
registration process separately for each repeater)
T At least one of the AC adapters supplied with the repeaters
 Use ONLY the power adapter that came with your repeater. A different power
adapter may cause an electrical hazard or damage the repeater.