NEC DTERM DTL-RPT-1 - Manual (Page 15)

D
term
Cordless DECT Document Revision 1
Repeater Guide 2 - 5
___________________________________________________________________________________
___________________________________________________________________________________
4.1 Automatic Registration
The repeater seeks out the base with strongest DECT/GAP signal and
automatically registers to that base.
1. Make sure the repeater is powered off (i.e., the AC power adapter is not
connected).
2. Set the base into registration mode. (Consult the owner's manual that
came with your base station for more information).
3. Use the AC adapter to connect the repeater to a standard 120 V AC
outlet. (Do not use a power outlet controlled by a wall switch.) The LED
on the repeater flashes briefly, then remains on and steady.
 If the LED continues to flash, try registering the repeater again.
The repeater is now registered to this base and is ready to use.
You can safely disconnect the power and move the repeater to the selected
location; the repeater will stay registered to the base.
4.2 Registration for a Daisy-Chain Layout
Registering the repeaters to operate in a daisy-chain or sequential layout
requires network administrator access and configuration software. Contact
your installer or refer to the DTL-RPT-1 Administrator's Guide (provided with
the configuration software) for more information.
4.3 Registering to a Different Base
Once the repeater is registered, you need to reset it before you can change
the registration to a different base. If you want to reset the repeater and clear
its registration, follow the steps below:
1. Disconnect the power.
2. Reconnect the power for 1 to 5 seconds, and disconnect it again.
3. Reconnect the power for 25 to 35 seconds.
4. Disconnect the power, and perform the registration procedure with the
new base.