NEC MultiSync V462 - Manual (Page 24)

English-22
H RESOLUTION
VGA, RGB/HV inputs only
Adjusts the horizontal size of the image. -
V RESOLUTION
VGA, RGB/HV inputs only
Adjusts the vertical size of the image. -
INPUT RESOLUTION
VGA, RGB/HV inputs only
If there is a problem with signal detection, this function forces the monitor to display the signal at
the desired resolution. After selection, execute “AUTO SETUP” if required.
If no problem is detected, the only available option will be “AUTO”. AUTO
ASPECT Select the aspect ratio of the screen image. NORMAL
NORMAL Displays the aspect ratio the same as it is sent from the source. -
FULL Fills entire screen. -
WIDE Expands a 16:9 letter box signal to fi ll entire screen. -
DYNAMIC Expands a 4:3 pictures to fi ll the entire screen with non-linearity. Some of the outside image area
will be cut off due to expansion. -
1:1 Display the image in a 1 by 1 pixel format. (If the input resolution is higher than a 1920 x 1080
resolution, the image will be scaled down to fi t the screen.) -
ZOOM The image can be expanded beyond the active display area. The image which is outside of active
display area is not shown. -
ZOOM Maintains the aspect ratio while zooming. -
H ZOOM Amount of horizontal zoom.
V ZOOM Amount of vertical zoom.
H POS Horizontal position.
V POS Vertical position.
RESET Resets the following settings within the ADJUST menu back to factory setting: AUTO ADJUST,
H POSITION, V POSITION, CLOCK, PHASE, H RESOLUTION, V RESOLUTION, ASPECT. -
AUDIO
VOLUME Increases or decreases output volume level. -
BALANCE Adjust the balance of L/R volume.
Press + button to move the stereo sound image to right.
Press - button to move the stereo sound image to left. CENTER
TREBLE To accentuate or reduce the high frequency sound.
Press + button to increase TREBLE sound.
Press - button to decrease TREBLE sound. 0
BASS To accentuate or reduce the low frequency sound.
Press + button to increase BASS sound.
Press - button to decrease BASS sound. 0
SURROUND Artifi cial surround sound.
Note: Audio out is disabled when this function is set to ON. OFF
PIP AUDIO Selects source of PIP audio. MAIN AUDIO
LINE OUT Selecting “VARIABLE” enables control of the line out level with the VOLUME button.
Note: LINE OUT is disabled when SURROUND is set to ON. FIXED
AUDIO INPUT Selects audio input source [IN1], [IN2], [IN3], [DPORT], [HDMI], [OPTION]*. Depend on
signal input
RESET Resets “AUDIO” options back to factory settings. -
SCHEDULE
OFF TIMER Sets the monitor to power off after a length of time.
A time between 1 to 24 hours is available. OFF
SCHEDULE SETTINGS Creates a working schedule for the monitor to use. -
SCHEDULE LIST List of schedules. -
DATE & TIME Sets the date, time, and daylight saving region. Date & time must be set in order for the
“SCHEDULE” function to operate. See page 28.
YEAR Confi gures the year for the real time clock. -
MONTH Confi gures the month for the real-time clock. -
DAY Confi gures the day for the real-time clock. -
*: The product you purchased may not have this feature.