NEC MultiSync V462 - Manual (Page 9)

English-7
English
3. Installing and removing optional table
top stand
CAUTION: Installing and removing the stand must be done
by two or more people for V462, by four or more
people for V651.
To install, follow those instructions included with the stand or
mounting apparatus. Use only those devices recommended
by the manufacturer.
NOTE: Use ONLY thumbscrews which are included in the
monitor. For V651, use ONLY the thumbscrews
which are included with the optional table top
stand.
When installing the stand, handle the unit with care to avoid
pinching your fi ngers.
Optional table top stand
Table
Protective Sheet
NOTE: For V462, install the stand so the long end of the
feet face forward.
For V651, install the stand in the direction of the
arrow which, is on the optional stand.
Use the ST-4620 for the V462, and the ST-651 for
the V651.
4. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the enclosure
to allow heat to disperse, as shown below.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and mounting apparatus; especially when you use
monitors in multiple screen.
NOTE: The sound quality of the internal speakers will
differ according to the acoustics of the room.
5. Prevent Tipping
When using the monitor with the optional table top stand
fasten the LCD to a wall using a cord or chain that can
support the weight of the monitor in order to prevent the
monitor from falling. Fasten the cord or chain to the monitor
using the provided clamps and screws. For the V651, the
clamps and screws are included with the optional table top
stand.
Screw
Cord or chain
Clamp
204 mm (V462)
400 mm (V651)
Screw Holes
Before attaching the LCD monitor to the wall, make sure that
the wall can support the weight of the monitor.
Be sure to remove the cord or chain from the wall before
moving the LCD.