NETGEAR ADSL Firewall Router DG834 - Manual (Page 201)

NETGEAR VPN Configuration E-1
202-10005-05, June 2005
Appendix E
NETGEAR VPN Configuration
DG834 to FVL328
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DG834 to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html ).
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table E-1. Profile Summary
VPN Consortium Scenario: Scenario 1
Type of VPN LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security Scheme: IKE with Preshared Secret/Key (not Certificate-based)
Date Tested: June 2004
Model/Firmware Tested:
NETGEAR-Gateway A DG834 firmware version V2.10.17
NETGEAR-Gateway B FVL328 with firmware version V2.0_07
IP Addressing:
NETGEAR-Gateway A Static IP address
NETGEAR-Gateway B Static IP address