NETGEAR ADSL Firewall Router DG834 - Manual (Page 206)

Reference Manual for the ADSL Firewall Router DG834
E-6 NETGEAR VPN Configuration
202-10005-05, June 2005
3. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834.
a. Open the command prompt (Start -> Run -> cmd)
b. ping 172.23.9.1
Figure E-4: ping 172.23.9.1
Note: The pings may fail the first time. If this happens, try the pings a second time.
DG834 with FQDN to FVL328
This appendix is a case study on how to configure a VPN tunnel from a NETGEAR DG834 to a
FVL328 using a Fully Qualified Domain Name (FQDN) to resolve the public address of one or
both routers. This case study follows the VPN Consortium interoperability profile guidelines
(found at
http://www.vpnc.org/InteropProfiles/Interop-01.html ).
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.