NetComm NP2724M - Manual (Page 30)

This command configures queue weight for weight round robin.
Format qos wrr weight <1-15> queue <1-4>
Mode Global Config
8) qos dscp-remark
Note: This command only supports on the following switches,
This command is used to change DSCP value if the outgoing packet is an
IP packet. Select an ACL Entry Name as the criterion and then enter New
DSCP Value as the action. Once the criterion is hit, the DSCP value will be
changed.
Format qos dscp-remark acl_entry_name <name> new_dscp_value <0-63>
Mode Global Config
set
1) set IGMP
Configure IGMP snooping.
1.1) set igmp enable
This command enables igmp snooping.
Format set igmp enable
Mode Global Config
1.2) set igmp disable
This command disables IGMP snooping.
Format set igmp disable
Mode Global Config
1.3) set igmp last-memberquery
This command specifies last member query interval.
Format set igmp last-memberquery <1-200>
Mode Global Config
1.4) set igmp last-membercount
This command specifies last member count.
Format set igmp last-membercount <1-20>
Mode Global Config
1.5) set igmp query-interval
This command specifies igmp query interval<secs>.
Format set igmp query-interval <10-600>
Mode Global Config
1.6) set igmp query-resinterval
This command specifies igmp query response interval<secs>.
Format set igmp query-resinterval <0-200>
Mode Global Config
1.7) set igmp robustness
This command specifies robustness variable.
Format set igmp robustness <1-20>
Mode Global Config
1.8) set igmp router-port
This command specifies igmp router port.
Format set igmp router-port ports <port list>
Mode Global Config
e.g. Switch(config)# set igmp router-port ports 1-10
2) set igmp-querier
This command configures igmp querier.
Format set igmp-querier {enable | disable}
NP2724M User Manual 29